Why does the sticking phenomenon occur in the operation of the shade machine?
The phenomenon of sticking and punching sometimes occurs in the work of a lampshade machine. This phenomenon may cause the work to be carried out to fail smoothly. Therefore, we must pay attention to the corresponding problems when working. Finding the cause can reduce the occurrence of this phenomenon. What are the reasons?
First, the quality of the adhesive is too bad or does not meet the requirements caused by the sticky red, the solution: use a fine mesh first sieve powder, etc., and then evenly pressed into tablets. The workshop is too wet to reduce the wetness of the workshop.
Secondly, the surface of the punch is damaged, or the surface of the punch is not flat, which may cause the characters carved in the die to have deep corners. This can clean the punch or add a little lubricant to the punch. Pay attention to the maintenance of the machine to avoid sticking.
Another possibility is that the powder or the particles are soaked with water too much, and the moisture is controlled to check whether the powder or the particles are wet. Or because the quality of raw materials is too bad, it is easy to cause unevenness and poor time. The solution is to first screen the raw materials and wait for the quality requirements, and also control the time.
In short, during the work of the lampshade machine, the above-mentioned aspects will make the machine appear viscous. Therefore, we can pay attention to the above mentioned contents in the subsequent use, so that it can be used more smoothly, and everyone can do this. Simple understanding.