Blowing machine driving system is to drive the important parts of the machine, so we have to understand this part of the simple, so that in the later use, you can understand the situation in more detail, if there is a problem can also be handled accordingly, see below Summary of understanding.
The blow molding machine adopts a servo electric drive system, which reduces the waste of electric energy caused by the constant opening of the oil pump or compressor during operation of the hydraulic system or the pneumatic system. Therefore, the servo electric drive system can save more than 50% energy than the hydraulic system and pneumatic system. The servo electric drive also avoids the traditional hydraulic drive oil leakage, resulting in the contamination of the machine and product, can meet the various industries clean the machine and product. Requirements: The embryo embedding mechanism is equipped with an advanced servo-electric drive system. It uses a servo motor to drive the embryo-loaded sliders to run with linear guides. It is stable in operation, accurate in step positioning, and energy-saving. The drive system of the blow-molding machine is very important. Ignore.
In short, when we use the blow molding machine, we must pay attention to the above content, so that in the subsequent use will be relatively attention to ensure the use of the effect. The drive system of the blow molding machine must be inspected at any time, and the damage must not be severely repaired. In severe cases, it cannot be used.